Sunday, November 9, 2014

Fuse Block Wiring

I started to wire the additional Fuse Block that I have installed onto the back of the passenger side Hush Panel. Right now I just have the once circuit for the Annunciator External Loudspeaker wired. I have a 10 Amp Blade Fuse in the block for this circuit which should be good enough for the 100W Annunciator Loudspeaker as it's only drawing around just shy of 8 Amps. I still have to install that into the nose of the car though.


I have my wire running from the fuse block into a four terminal block that I can mount the wires to using Ring Terminals crimped onto the ends of the wires from the fuse block and then screwed onto the Terminal Block, this way the install should be easier if I ever need to change something later on down the road as this projects gains complexity.

I ran the Red 10 AWG wire through the same hole that the old Antenna wire went through just behind the side Air Extractor Vent, up inside the fender and across to where it will eventually be hooked to the battery through an in-line fused circuit breaker rated at 100 Amps, this will protect the entire block and as mentioned in previous posts it will allow me to disable that entire block right at the battery by tripping the breaker. Very handy for any car shows I may do.

Here is a little video I made earlier today showing a little more about what I have done here, Enjoy. ;)